ANTI-HARASSMENT TRAINING RESOURCE CENTER

DOWNLOAD YOUR TRAINING MATERIALS HERE

Training Center Functionality (check all that apply)

Housekeeping - Training Center is clean and organized

Welding booths are functional

Availability - the training center is readily available for use by the members and/or new recruits

Shop safety has been evaluated and all issues have been addressed

Consumables are fully stocked

Minimum testing material kept on hand:

500 plate coupons

2,000 backing strips

300 tube coupons

Testing materials are recut no less than five (5) times before becoming scrap

Open welding electrodes are kept in an overn between 150 to 200 degrees

All MIG wire is removed daily and placed in sealed plastic or dry box that is moisture resistant

All TIG wire is kept in moisture-resistant containers

Stick and MIG test plates:

Cut 7" long out of 6" flat bar

Are at least 1/2" thick but not over 1"

Backing bars are 1/4" x 1" x 9"

Tube coupons are 5" long. Thickness may vary with training, but is no less than schedule 80 or greater than XXS

Scrap from plates is being used for arc gouge training

Training materials are being cut with plasma or torch using track burner

Proceeds from scrap are being put back into the local training center

Test Booths

All booths are set up for 6G tube training in all three positions of plate (horizontal 2G, vertical 3g, overhead 4G)

Test stands have proper mechanical devices to hold test coupons

Welding machines are set up outisde of the testing booths with leads and MIG guns run into booths

Grounds are run from machines to test stands with ground clamps no greater than 18" from work

No welding of any kind and no welding or tacking of test coupons occurs on test stands

Thank you! Your form has been submitted.